![background image](http://html.mh-extra.com/html/canon/lv-7555/lv-7555_specifications_62526021.webp)
MR3P Series EXPAND SERIAL COMMAND FUNCTION SPECIFICATION
Software Engineer Division
8.5.3 CF_CLAMP
COMMAND
COMMAND “CF_CLAMP_%1”[CR]
%1
“0000-0127”---- Directly set Clamp setting value.
“UP”------------------ Clamp setting value+1
“DN”------------------ Clamp setting value-1
Details
Set Clamp of PC signal.(Only valid when it is in the usual Power On state.)
The value set by this Command will not be saved to the projector..
Therefore, when ALL OFF the projector, the value will return to the
original setting.
(stay in Stand By mode.)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ
COMMAND.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
8.5.4 CF_H-POS
COMMAND
COMMAND
“CF_H-POS_%1”[CR]
%1
“0000-nnnn”-- Directly set Horizontal Position
“nnnn” means maximum value.
This result of current Total Dots value – Display Dots.
“UP”---------------- Horizontal Position value +1
“DN”---------------- Horizontal Position value -1
Details
Set horizontal position of PC signal.(Only valid when it is in the usual Power
On state.)
This value set by this Command will not be save do the projector.
Therefore, when ALL OFF the projector, the value will return to the
original setting. (stays in Stand By mode)
Note:When %1 is directly specified, this command is not enough to execute
for the screen. To show up on the image, issue CF_SETPCADJ
COMMAND.
Acceptable
“000”[CR]
Response
Unacceptable “101”[CR] ---- When Input is Video Series
Page 21 / 53