Canon imageRUNNER ADVANCE 6055 Series, Service Manual

Page: 922 / 1406

8
8
8-140
8-140
Service Mode > COPIER > OPTION > FEED-SW
Service Mode > COPIER > OPTION > FEED-SW
■
ENV-SET
COPIER > OPTION > ENV-SET
ENVP-INT Temp, humid/Fix Roll temp log get cycle
Lv.1 Details To set the cycle to obtain log of the temperature and humidity inside
the machine or the surface temperature of the Fixing Roller.
As the value is incremented by 1, the cycle is increased by 1 minute.
Obtained log can be displayed by selecting the following: COPIER >
DISPLAY > ENVRNT
Use case At trouble analysis
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 480
Unit 1 minute
Default value 60
Related service mode COPIER> DISPLAY> ENVRNT
DRY-CISU ON/OFF of condensation prevention mode
Lv.1 Details To set ON/OFF of condensation mode.
When droplets are appeared on the Scanner Unit due to
condensation and image failure or E225 occurs, set “1: ON”.
By selecting 1, the Scanner Unit (paper front) stops the fan for
15 seconds and the Scanner Unit (paper back) lights LED for 30
seconds from the next startup.
Use case When droplets are appeared on the Scanner Unit due to
condensation and image failure or E225 occurs
Display/adj/set range 0 to 1
0: OFF (Normal mode), 1: ON (Anti-condensation mode)
T-8-62
■
FEED-SW
COPIER > OPTION > FEED-SW
TRY-CHG Set of Delivery Tray switch at tray full
Lv.2 Details To set the Delivery Tray switching control when the Delivery Tray of
the Finisher reaches to the full level.
If Tray A/B is selected as a delivery tray, tray is switched to the Tray A
when the Tray B reaches to the full level. At this time, after removing
papers on the Tray B, paper is delivered to the Priority Tray when 0
is set. When 1 is set, paper is output followed by the previous job.
Use case Upon user’s request
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: Deliver to the Priority Tray, 1: Deliver followed by the previous job
Default value 0
REG-SPD Speed adj of Rgst Roller: plain paper
Lv.2 Details To adjust the Registration Roller speed when 1/1 speed is set for
plain paper, etc.
Increase the value if the image at the leading edge of paper shrinks
in the feeding direction, and decrease the value if it expands.
Decrease the value if wavy-line image occurs.
If these symptoms are not alleviated after adjustment is made,
replace the Registration Roller.
Display/adj/set range -50 to 50
Unit 0.10%
Default value 0
Related service mode COPIER> OPTION> FEED-SW> REG-SPD2, REG-SPD3
INSRT-SW [Not used]
Lv.1 Details -