Canon imageRUNNER 5065 series, Service Manual

Page: 71 / 596

Chapter 2
2-15
F-2-62
[1] Feeding direction of paper
Make the numerical value smaller = the left margin is reduced
Make the numerical value larger = the left margin is increased
(1mm shift by changing every 10 in the setting value)
2.2.21 Adjustment of image leading edge margin
0015-4677
iR5065 / iR 5055 / iR5075 / / /
1) Select the following in the service mode: COPIER > ADJUST > FEED-
ADJ > REGIST
2) Change the setting value to adjust.
(1mm shift by changing every 10 in the setting value)
Check that the leading edge margin of the image picked up from each
cassette/deck is as follows : L1=4.0 +1.5 /-1.0mm
F-2-63
[1]Feeding direction of paper
2.2.22 Mounting of the Host Machine
0015-4745
iR5065 / iR 5055 / iR5075 / / /
<Storing of the drum rotational tool and the grip>
1) Detach the lower rear right cover [1].
- 2 screws [2]
F-2-64
2) Store the following parts:
- Drum rotational tool [1]: store it along with the collecting toner cap to
the hole of the pullout grip at the top of the collecting toner case [2].
- Grip: insert to the grip storing area [3]
F-2-65
3) Attach the lower rear right cover removed in the step 1).
<Attaching of the grip cover>
1) Attach the grip cover (small) [1] to the latch face cover [2].
F-2-66
2) Attach the 3 grip covers (large) [1] and the cover [2] that was attached in
the step 1).
image
L1
[1]
image
L1
[1]
[1]
[2]
If pulling out the pullout grip fully, it makes the drum rotational tool and
the cap fail to be inserted.
It is easy to insert them if pulling the pullout grip at moderate position
shown in the figure below.
[1]
[2]
[3]
[1] [2]