Placing Originals
1-40
1
Introdu
ctio
n to
F
a
x Function
s
•
If the same original is fed through the feeder repeatedly, the original may fold or become
creased, and make feeding impossible. Limit repeated feeding to a maximum of 30 times
(this number varies, depending on the type and quality of the original).
•
If the feeder rollers are dirty from scanning originals written in pencil, perform the feeder
cleaning procedure. (See Chapter 7, "Routine Maintenance," in the
Reference Guide
.)
•
Always smooth out any folds in your originals before placing them into the feeder.
1
Adjust the slide guides to fit the size of your originals.
2
Neatly place your originals with the side to be scanned face
up in the original supply tray.
Place your originals as far into the feeder as they will go, until the Original Set
indicator is lit.
If any dirt on the original scanning area is detected when the originals are placed
in the feeder, the following screen appears. Even though streaks may appear on
the scanned image, you can continue to scan your documents by pressing
[Done].
It is recommended, however, that you open the feeder, clean the scanning area,
and then close the feeder. The following screen will not appear once the
scanning area is clean.
Original Set Indicator
Summary of Contents for imageRUNNER 2830
