Canon imagePASS-R1, Service Manual

Page: 9 / 84

Precautions
This section includes information about how to safely operate and service the
imagePASS
and how to avoid
damage to imagePASS components.
Report shipping damage
If there is evidence of shipping damage, save the shipping boxes and damaged parts. Call the shipper immediately to file a claim
and notify your authorized service/support center.
Do not change an existing network
The
imagePASS
is probably connected to an existing Local Area Network (LAN) based on Ethernet hardware.
The network is the link between the customer’s computer, existing laser printers, and other prepress equipment. Never disturb
the LAN by breaking or making a network connection, altering termination, installing or removing networking hardware or software,
or shutting down networked devices without the knowledge and express permission of the site administrator.
Do not assign an IP address to the imagePASS
Only the site administrator should assign an IP address to a network device, including the imagePASS . If you enter an incorrect
IP address for the imagePASS , errors may occur on connected devices.
Handling boards
When handling a printed circuit board, do not bend it. Hold it by opposing edges, rather than by the corners.
Handling the hard disk drive
To ensure that you do not damage the hard disk drive, do the following:
• Follow electrostatic discharge (ESD) precautions.
• Keep magnets and magnetic-sensitive objects away from the hard disk drive.
• Do not loosen or remove the screws on the top of the hard disk drive. Doing so voids the warranty.
• Handle the hard disk drive by its sides and avoid touching the printed circuit board.
• Do not drop, jar, or bump the hard disk drive.
• Before you remove or install a hard disk drive, allow it to reach room temperature.
Avoid magnets
Keep magnets and magnetic-sensitive objects away from electronic components, especially the hard disk drive.
1. Introduction
4