Canon im2520f, Setup Instructions, Page: 58 / 143

9219
– 5 –
4346-7741-02
■
Checking the Paper Reference Position
1. Turn ON the copier.
2. Call the Tech. Rep. Mode to the screen.
*
See the Service Manual for the procedure.
4348P005CB
3. Follow these steps to call the Adjust mode to
the screen.
* With the Tech. Rep. Mode displayed on the
screen, press the Stop key and then Start
key, in that order.
4. Touch “Printer” to call up the Printer screen.
4348P003CA
5. Touch “Registration (CD)” to display the
Registration (CD) screen.
4348P009CA
6. Touch “Test Print” to display the Test Print
screen.
4348P015CA
7. Touch “Duplex.” (This highlights the “Duplex”
key.)
4348P017CA
8. Press the Start key on the control panel.
(The copier will produce an output of a test
print.)
4002O280CB
9. Measure width A on the test print of second
side and check to see if the measured
dimension falls within the specified range.
<Specifications: 10 ± 2.0 mm>
4346U041AA
A
10. If the measured width A falls within the
specified range, press the Panel Reset key
to recall the Basic screen.
11. If the measured width A falls outside the
specified range, perform the following
procedure to adjust the paper reference
position.