COPYRIGHT © CANON ELECTRONICS INC. 2008 CANON DR-X10C FIRST EDITION
4-21
CHAPTER 4 INSTALLATION & MAINTENANCE
III. MAINTENANCE
1. User Maintenance
A list is shown below. Refer to the “User Manual” for the details.
[ : Cleaning,
z
: Replace]
Intervals
No. Location/parts
As
required
500,000
sheets
Details
1 Main
body
Wipe the main body with a cloth
dipped into water and wrung tightly,
then wipe dry.
2
Pickup inlet/feed path
Using a blower, etc., remove remained
dust and paper powder.
3 Pickup
roller
Feed roller
Retard roller
z
Wipe the rollers with a cloth dipped
into water and wrung tightly, then wipe
dry. The expected life is 500,000
sheets. Refer to Note 3.
4 Platen
roller
Press the [Stop] key on the operation
panel, and while rotating it gradually,
clean the black and white background
section in the same way as for the
above roller. Remove the brush sec-
tion with a cotton swab, etc.
5 Other
rollers
Clean in the same way as for the
above roller.
6 Reading
glass
Wipe the reading glass with a cloth
dipped into water and wrung tightly,
then wipe dry. Refer to Note 4.
7 Ink
cartridge
z
Clean the discharge outlet of the ink
head with soft cloth or paper or a cot-
ton swab. Refer to Note 5 for re-
placement time.
8
Parts to which ink is
attached
(Pre-imprinter)
Wipe these parts with a cloth dipped
into water and wrung tightly, then wipe
dry. Refer to Note 6.
Table 4-301
Note 1:
The supplied cleaning cloth is used to clean the reading glass and rollers.
Note 2:
Clean with the supplied roller cleaning sheet in the user mode.
Note 3:
If the number of sheets fed with the roller exceeds 500,000 sheets, a replacement
message is displayed on the operation panel LCD and computer screen.
Note 4:
When the [Start] key on the operation panel is pressed, the LED on the reading unit
lights and stains on the reading glass can be confirmed.
Note 5:
The expected life of the ink cartridges is not shown on the “User Manual”.
Note 6:
Since post-imprinter parts are not easily available, they are not described in the “User
Manual”.
