COPYRIGHT © CANON ELECTRONICS INC. 2008 CANON DR-X10C FIRST EDITION
3-51
CHAPTER 3 DISASSEMBLY & REASSEMBLY
VIII. UPPER UNIT-3 (FEED SYSTEM)
1. Platen Roller
1) Remove the screws
{
1
(stepped) on both
sides. Then, rotate the platen roller
{
2
in
the direction of the arrow, align the bearing
{
3
with the side plate notch
{
4
, and re-
move the platen roller.
Figure 3-801
2. Registration Roller
1) Remove the entrance upper unit.
2) Open the ends (marked with
¼
) of both
bearing holders
{
1
and unhook the fitting
parts and remove the registration roller unit
{
2
.
Note:
Since the coil spring in the registration
roller unit may be detached, do not lose
it.
Note:
Since the entire registration roller unit
and a single registration roller are set as
service parts, select them as required.
Figure 3-802
