Canon DR-6080, Service Manual

Page: 70 / 366

2 - 46
COPYRIGHT © 2003 CANON ELECTRONICS INC. CANON DR-6080/9080C REV.0 SEPT. 2003
CHAPTER 2 FUNCTIONS & OPERATION
2. Endorser
An optional endorser can be installed at the
eject tray of the DR-6080/9080C to print an
8-digit number and a stamp on scanned
documents, such as for checks. The ED600 for
the DR-5020/5080C is used.
However, when the ED600 is used on the
DR-6080/9080C, the feed and reading speeds
are slowed. The maximum feed speed becomes
the maximum feed speed of the ED600, 588
mm/sec. In the case of color at 400/600 dpi, the
noise from the ED600 becomes high.
The endorser should be installed by a
service technician. For the procedure, refer to
“CHAPTER 4: INSTALLATION &
MAINTENANCE”. The specifications of the
endorser are shown in Fig. 2-802.
No. Item Specification
1 Printing method Stamping
2 Supported Document Size
1) Width
2) Length
3) Thickness
130-257mm
a) 70-93mm (Check mode)
b) 70-297mm (A4 mode)
a) 0.08-0.15mm (Auto feed)
b) 0.08-0.20mm (Manual feed)
Note: A4/Letter landscape feed is not supported
3 Stamping position
1) Width direction
2) Feeding direction
Slide the print unit manually from side to side. The range
is 53mm to the left and 100mm to the right based on the
center of the feed path. Make sure the stamping area
does not deviate from the document.
Control with the adjusting dial at the document feeder.
Stamping is not executed if the travel distance exceeds
the length of the document.
a) Stamping area for the check mode
In the center, within 24mm of either side
b) Stamping area for the A4 mode
In the center, within 26mm of either side
Note: The area size indicates the size of the date area.
100mm 53mm
24mm/26mm
24mm/26mm
Rear
Table. 2-802-a