4
4-18
Performing Setup from the Control Panel
7.
When you have finished entering protocol settings, choose Exit Protocol Setup, and
then choose Service Setup.
8.
Enter the appropriate settings for the services you will use.
The options are described in detail in the following pages.
T
O
EXIT
N
ETWORK
S
ETUP
1.
When you have finished entering service settings, choose Exit Network Setup.
2.
Choose Yes when prompted to save changes.
3.
From the main Setup menu, choose another Setup or choose Exit Setup.
Port Setup options
Network Setup
Port Setup
To configure the ColorPASS, choose the port type you use and enter the settings for
that port. Since network setups are nested, the names of higher-level menus are
shown in this chapter to the left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the ColorPASS.
Ethernet Speed
Auto Detect/1 Gbps/100 Mbps Full-Duplex/100 Mbps Half-Duplex/
10 Mbps Full-Duplex/10 Mbps Half-Duplex [Auto Detect]
Select an appropriate setting according to the settings of the network to which the
ColorPASS is connected.
N
OTE
:
When you select Auto Detect, make sure that the auto-negotiation settings
for speed and duplex are configured for the network port to which the ColorPASS is
connected. Similarly, when you select a different setting such as 100 Mbps
Full-Duplex, make sure the same settings are configured for the network port.
N
OTE
:
The 1 Gbps (gigabit per second) setting is full-duplex.
