Installation and Setup
5
2.0
Installation and Setup
The
LaserLight2
remote display is easily set up and configured. This section describes basic installation, AC
wiring, RS-232, RS-422 and 20 mA current loop connections. Once installation and set up is complete, see
Section 3.0 on page 16 for information on configuring the remote display.
The
LaserLight2
has no on/off switch. Before opening the unit, ensure the power cord is disconnected
from the power outlet.
Use a wrist strap for grounding to protect components from electrostatic discharge (ESD) when working
inside the enclosure.
2.1
Unpacking
Immediately after unpacking, visually inspect the
LaserLight2
for damage. If any parts were damaged in shipment,
notify Rice Lake Weighing Systems and the shipper immediately. The shipping carton contains the
LaserLight2
,
and the following components:
•
Weather tight, IP66 rated enclosure with a CPU board and either mounting flanges or a VESA mount
•
Installation manual
Remove the protective plastic on the lens of the LaserLight as it will obscure the display over time and
become very difficult to remove.
2.2
Wall Mounting
The
LaserLight2
remote display can be mounted to any vertical surface or pole using 1/4" hardware or a VESA
mounting bracket for increased versatility.
2.2.1
Flange Mounting Brackets
The flange tab mounting comes in both 4" or 6" brackets.
Select a site and secure the remote display to a wall using included hardware and the mounting holes on the flange
tabs.
Figure 2-1. Side Mount Flange Brackets for 6" and 4" Models
An optional pole mounting kit is required when installing the remote display on a pole. The kit fits 4" - 8" poles
(see Section 4.3 on page 28).
WARNING
Important
175305
175306
1.58" (4.0 cm)
10"
(25.4 cm)
1.58" (4.0 cm)
8"
20.3 cm)
Summary of Contents for LaserLight 2 Series
Page 36: ......
