6
LaserLight2 Technical Manual
2.2.2
VESA Mounting Bracket
The VESA mount allows for a wide variety of mounting options to be compatible with the
LaserLight2
.
Figure 2-2. VESA Mounting Bracket
The four mounting PEMs on the
LaserLight2
are threaded.
Refer to Figure 2-12 on page 15 and Table 2-8 on page 15 for applicable mounting bracket part numbers.
2.3
Wiring
The
LaserLight2
remote display provides three cord grips located on the underside of the enclosure; one for the
supplied A/C power cord, and two for serial communications. The
LaserLight2
remote display comes pre-wired.
Ribbon cables connect the CPU board to the digit display boards. Only the serial communications cable must be
connected.
The LaserLight remote display has no on/off switch. Before opening the unit, ensure the power cord is
disconnected from the power outlet.
Use the following steps to open and wire the remote display in Section 2.3.1.
1.
If the remote display is not open, loosen the captive screws located on the front of the remote display enclosure.
2. Pull the hinged display screen outward to open the enclosure.
2.3.1
AC Wiring
The
LaserLight2
power supply can run on either 115 or 230 VAC. The AC wiring is run through the cord grip to a
3-position AC terminal block bracket on the inside of the enclosure.
Figure 2-3. Power Supply Location and Wiring (non-UL Version Shown)
Wall Plate
Front View
Adaptor Plate
Side View
Adaptor Plate
0.38 in
(10 mm)
6.02 in
(153 mm)
1.02 in
(26 mm)
5.75 in
(146 mm)
5.00 in
(127 mm)
8.75 in
(222 mm)
7.87 in
(200 mm)
9.35 in
(237 mm)
7.87 in
(200 mm)
WARNING
Summary of Contents for LaserLight 2 Series
Page 36: ......
