11
INSTALLATION GUIDELINES
BRAKE SYSTEM VERIFICATION
CAUTION: Verify if braking system is operating
well before using a motorcycle equipped with a
Conversion System. If braking is failing, bring the
System to Camso dealer to solve the problem.
Verify that the brake lever is working correctly
and maintains adequate braking pressure. Action
the brake lever several times and maintain
pressure on the lever.
• If lever stays in place that means that it
correctly maintains braking system pressure.
• If you feel the lever going spongy, that means
that there might be pockets of air in the
system. The braking system must be bled.
BRAKE SYSTEM BLEEDING
To eliminate air in the braking system, perform
the following steps in sequence:
• Remove master-cylinder cover.
•
Slowly
pump the lever several times, watching
the fluid. Small air bubbles should be visible in
the oil contained in the master-cylinder.
• When there are no more bubbles, re-install
cover.
• Action the brake lever a few times and tie it in
the closed position during 24 hours.
• If the system maintains pressure after 24
hours, it is bled correctly.
• If the lever is even more closed after 24 hours,
perform the steps to bleed the system again.
