Campingaz 100 S CV KIT Instructions For Use Manual Download Page 7

Page: 7 / 44

- When cleaning, be careful to avoid clogging the burner holes. If the

holes are clogged, for example by food that has spilled over, clear

them with a non-metal brush.

- Clean greasy parts with soap and water or a non-abrasive

detergent.

- The pan support (3) can be removed for cleaning purposes by

pulling it upwards.

- To reattach the pan support, insert the legs into the holes on each

side of the stove (Fig. 8).

- Wait for the stove to cool down completely before placing the stove

inside the carry bag for storage.

- Store the equipment and the cartridge in a cool, dry and well-

ventilated area, out of reach of children. Never store in a basement

or cellar.

If the stove has not been in use for more than 30 days, check to

see if cobwebs or anything else is not clogging the burner openings

and its venturi tube; this could lead to decreased burner efficiency

or to a dangerous ignition of gas outside the burner.

2) Hose connecting the regulator and the stove

- Regularly check the condition of the hose. If it shows signs of

wear or cracking, please contact your local after sales service (see

separate sheet with contact details included in the package).

- If the stove will not be used for a long period of time disconnect the

cartridge as indicated in paragraph D.

- The date which is printed on the hose is the production date and

not the expiration date. The hose can be used without time limit as

long as it is not damaged.

In case of the injector becoming clogged (the equipment will not

light although the cartridge still contains gas), do not try to unclog

it yourself. Return the equipment to your retailer.

- Adjust the flame according to the dimensions of the container used

for cooking by turning the control knob. Do not use a pan or pot

with a diameter larger than 20 cm.

- If you would like to fine-tune the simmering temperature, adjust the

flame level by turning the control knob.

- In case of strong wind, place the stove behind a wall (distance

more than 20 cm ) facing off the wind so that the wind does not

make the burner flame flare up beyond the pan bottom.

2) Shutting down

After use, turn the control knob (1) clockwise to the “off” (●) position

(Fig. 6) to fully close off the gas supply.

D - REMOVING OR CHANGING THE CAMPINGAZ

470 PLUS CARTRIDGE

The cartridge may be removed even if it is not empty. Replace the

cartridge outside and away from other people.

- Wait for the stove to cool down.

- Check that the valves on stove and regulator are fully turned off by

turning their knobs clockwise (1 & 2) to their full extent.

- Detach the regulator (4) from the cartridge by unscrewing the

regulator (4), then lift it up (Fig. 7B).

- Push the regulator (4) onto a new cartridge and screw it

tight until you hear a click (approximately one-sixth of a turn)

(Fig. 7A). Do not force the cartridge to turn further than this or you

may risk damaging the Easy Clic

Plus System.

E - STORAGE - SERVICING

In case of flashbacks (ignition under the burner cap) switch the

product off, allow it to cool down (approximately five minutes), then

reignite the appliance. If the problem of flashbacks persists, then

please contact your local Campingaz

representative.

1) Stove

Ensure that your stove is regularly maintained, and it will give you

many years of excellent service.

- Do not clean the stove while it is in operation. Wait for it to cool

down, to avoid burning yourself on the hot parts (pan supports,

burners).

Possible problems / Corrective action

Possible problems

Probable causes / Corrective action

The burner does not light up

The burner does not burn smoothly or goes out

Unstable blowing flames

Large plume of flame on the burner surface

Flame at the injector

Burning leak around a union

Insufficient heat

Burning leak behind the adjustment knob

- Poor gas supply

- Regulator not operating properly

- Pipe, valve, venturi tube or burner holes obstructed

- Regulator valve is turned off

- Check that gas is present

- Check the pipe connection