Campden instruments 7000smz, Instruction Manual

Page: 18 / 39

18
6.6 Automatic operation – Profile Repeat Mode
Once a cut has been taken as described manual slice procedure, the speed profile of
that cut is stored in memory and the instrument is able to repeat that profile under
automatic conditions. All that is further required is for the number of sections to be
entered. The user can select if the slice operation finishes at the end point of the
slice or automatically retracts to the start point ready for the next slice (see section
6.10).
If you try to operate the instrument in the automatic mode without having previously
set a cutting profile, via the manual slice procedure, the display will indicate
‘NO
SLICE PROFILE HAS BEEN CREATED
’. This display will time out and revert to the
basic manual operating screen.
When a satisfactory cut profile has
been
made, press the
‘AUTO
REPEAT
’ key twice until the profile
repeat screen is displayed. The led
adjacent to that key will be illuminated
in red as a warning.
Use the or keys to input the
number of cutting cycles required.
Press the
‘SLICE ON/OFF’ key to
commence cutting.
The instrument will now carry out the
number of cycles under automatic
control.