Camille Bauer SINEAX V604s, Operating Instructions Manual

Page: 10 / 19

10 Operating instructions V604s Be Camille Bauer
6.5 Measured values
Triggering action
Address Description Data type # Default Description
40209 ACTION UINT16 0 This register starts actions.
Action Description
18
19
Input 1: With short-circuited input terminals, the line calibration is realised and the measured
parameters are stored in the device.
This procedure is indicated by a fl ashing green LED.
Line calibration at Input 2 (same as Input 1)
40210 ACTDAT Additional information for the implementation of an action.
Simulation of output variables
• Writing into the PERCENT1, PERCENT2, OUTPUT1, OUTPUT2 registers interrupts the signal fl ow to the respective
variable and the desired value is specifi ed (However, percent and output value cannot be simulated simultaneously).
The status of the simulation mode can be read in the STATUS2 status register.
• The simulation mode is terminated by writing 0 into the respective bits in the STATUS2 register.
Current measured variables
Address Description Data type # Default Description
40257 STATUS1 UINT16 0 Status 1
Bit Description
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15 Reserved
Reserved
Device fault
Parameter fault
Sensor breakage
Input 1
Sensor short circuit Input 1
Reserved
Sensor breakage
Input 2
Sensor short circuit Input 2
Reserved
Alarm 1
Alarm 2 (relay 1 status before inverting)
Limit value 1
Limit value 2
Relay 1 status
Device reset or new parameter values
40258 STATUS2 UINT16 0 Status of the simulation mode: A set bit indicates the simulation mode of the respective register.
Bit Description
0
1
2
3 Output 1 (PERCENT1)
Output 1 (OUTPUT1)
Output 2 (PERCENT2)
Output 2 (OUTPUT2)
The simulation mode is terminated by writing zeros into the respective bit positions (0..3).
40259 INPUT1 REAL 0.0 Measured value Input 1
40261 INPUT2 REAL 0.0 Measured value Input 2
40263 MEAS1 REAL 0.0 Measured variable for Output 1
40265 MEAS2 REAL 0.0 Measured variable for Output 2
40267 LIMIT1 REAL 0.0 Measured variable for Limit value 1
40269 LIMIT2 REAL 0.0 Measured variable for Limit value 2
40271 T_JUNCTION1 REAL 0.0 Cold junction temperature Input 1
40273 T_JUNCTION2 REAL 0.0 Cold junction temperature Input 2
40275 ELAPSED UINT32 0 Operation hour counter [s ]
40277 PERCENT1 REAL 0.0 Output 1: Scaled output variable in %
40279 PERCENT2 REAL 0.0 Output 2: Scaled output variable in %
40281 OUTPUT1 REAL 0.0 Output 1 [mA] / [V]
40283 OUTPUT2 REAL 0.0 Output 2 [mA] / [V]