OMNI Tx-4.0
DCC
Programmable 2.4GHz Transmitter
For electric models with DCC
decoders and ESC
Or analogue DC models with up to 12 functions
P.O.Box 675
Blackburn, Lancs.
BB2 9QJ
UK
WWW.FOSWORKS.CO.UK
Tel 0(44)1254 814675
Rx
-
24 receiver circuit diagram for use with a DCC Interface module.
You no longer need that big transmitter anymore! The programmable
OMNI Tx
-
4.0
handheld transmitter will control your garden railway electric locomotives perfectly
from the palm of your hand. An
Omni Rx
-
4 or 24
receiver with be needed to work
with the
OMNI Tx
-
4.0
transmitter in DCC mode, but the Tx4.0 will also operate our
standard r/c Rx2 or Rx22 receivers installed in analogue DC models.
2.4GHz gives perfect glitch free control for up to 800 metres range with no
obstructions.
The Regulator Knob controls speed and direction. Forwards to the right, reverse to
the left. Cruise control is possible by turning off the transmitter while the train is run-
ning. Turn back on to instantly regain control. A controlled
E
-
stop is achieved by
moving the knob fully to the opposite direction. A maximum of 2 seconds from full
speed.
OMNI Tx-4.0
DCC
2.4GHz Handheld Transmitter
2 x AAA
Battery box lid
FUNCTION Buttons 1.2.3 /
4.5.6 /
7.8.9 /
10.11.12
Buttons 1.2.and 3. Operate DCC command functions
On a OMNI Rx4 receiver. These buttons are also used to re
-
program a receiver.
Functions
4,5
,and
6
are operated by holding the
green
shift button first, buttons
7,8
and
9
by holding the
red
shift button first and functions
10,11
and
12
by holding
down
both
shift buttons whilst pressing the function button required.
ON/OFF
Slide Switch
Slide down for ON
More Info
For more information
see overleaf
If Alkaline batteries are used up to 100 hours of contin-
uous use is possible, do not use rechargeable cells.
Regulator Knob Forwards and backwards Plus
12 function
buttons for
DCC
or DC operation
2.4GHz Technology by Timpdon Electronics
User programmable. With
E
mergency stop function
Requires an
OMNI Rx4 or Rx24
receiver with DCC interface module or
OMNI Rx2 or Rx22 with optional MCS switchers
Shift Buttons
Green
and
Red
Enables F4 to F12 in
combination with green
and red shift buttons.
LED’s 1 & 2
Indication of battery
and radio status plus
indications
during
bind and calibration.
Regulator
Knob
Turn right for forwards
and left for reverse. The
further you turn, the fast-
er
the
loco
goes.
Centre Stop.
Whilst moving, if a quick
stop is needed, move
the knob fully to the op-
posite direction for a
controlled
E
-
stop (Max 2
secs from full speed)
This knob is also used
when reprogramming the
top buttons.
