A-9
Scanner
®
2000 microEFM
Appendix A
If the expansion board is ordered with a Scanner 2000, it is installed at the factory. If the board is purchased
separately, the user will need to install it on the Scanner 2000 main board using the following instructions.
Installation (for boards purchased separately from a Scanner 2000)
Important Before installing the expansion board, remove all power from the Scanner 2000
(battery and external power). Remove wiring from the main board if necessary to guide
the expansion board into position.
The expansion board attaches to two headers positioned between the two large green terminal blocks on the
main board. To install, perform the following steps:
1.
Remove the standoff from packaging and push it into the hole near the middle of the main board until it
snaps into place.
2.
Guide the expansion board over the standoff and align the pins on the under side of the expansion board
with the headers on the main board. FAILURE TO ALIGN PINS AND HEADERS CAN RESULT IN
DAMAGE TO THE BOARD. When the board is positioned correctly, the text on both boards should face
the same direction.
3.
Gently press the expansion board and the main board together until the expansion board snaps into place
over the standoff.
4. Restore field wiring connections to the main board, if applicable, and install field wiring on the expansion
board.
5. Restore power to the Scanner 2000 and reboot the Scanner to allow it to detect the expansion board.
Align hole in
expansion board
with standoff.
Align pins on back
of expansion board
with black headers.
Figure A.14—Scanner 2000 input/output expansion board
Summary of Contents for Scanner 2000 microEFM
Page 1: ...NUFLO Scanner 2000 microEFM Hardware User Manual Manual No 9A 30165023 Rev 10 ...
Page 26: ...26 Section 1 Scanner 2000 microEFM ...
Page 104: ...A 18 Appendix A Scanner 2000 microEFM ...
Page 106: ...B 2 Appendix B Scanner 2000 microEFM ...
