500 mm
1080 mm
77°
94°
800 mm
500 mm
163,5 mm
43,5 mm
A
B
1
2
3
53x33x0,3 mm
53x13x0,3 mm
25x13x0,3 mm
2
1
4
5
6
3
1
2
3
EN
Wall mounting
With the Allen wrench, unscrew the blocking screws and remove the plate (figure 1). Fix the given plugs and
screw the entry panel (figure 2) at the desired height considering the position of the lens of the camera (figure
3). Run the hose with the system conductors as shown in figure 2. Extract the plastic terminal cover and wire
the connections (figure 4).
Once all the connections have been made, re-insert the terminal covers. For the installation of the accessories,
refer to the “Button module Installation” chapter.
Perform the programming and adjustment operations of the entry panel as described in the “Programming
Manual”. Install the front plate (figure 1).
Recessed installation
Install the recessed box at the desired height considering the position of the lens of the camera (figure 3), but
in advance, run the hose with the system conductors through one of the breaking points (figure 5 point A).
During installation of the recessed box it is possible to avoid any deformation by using the provided spacer
(figure 5 point B).
With the Allen wrench, unscrew the blocking screws and remove the entry panel plate (figure 1).
Introduce the cable connections in the special hole (figure 2) and fix the entry panel on the frame as shown in
figure 6; extract the plastic terminal cover and wire the connections (figure 4).
Once all the connections have been made, re-insert the terminal covers.
For the installation of the accessories, refer to the “Button module Installation” chapter.
Perform the programming and adjustment operations of the entry panel as described in the “Programming
Manual”. Install the front plate (figure 1).
H= 165 cm
(RECOMMENDED
HEIGHT)
Button Module Installation
Insert the button module as highlighted in figure 1, paying special attention to the top to bottom orientation
(figure 3).
Remove the glass and write the user names as shown in figure 2, paying special attention to the orientation
of the glass (figure 3).
Personalised labels
Dimensions
