Using the Cal Entertainment System™
2006 Portable Spa Owner's Manual
Page 65
LTR20061000, Rev. A
Opening the Player and Playing a Disk
1.
Press the OPEN button on the unit. The faceplate will gently lower and expose the disk drive (Figure 20).
Figure 206. Opening the faceplate
2.
Insert a disk in the disk drive.
3.
Flip up the faceplate.
WARNING:
DO NOT INSERT WET CDs or DVDs! The stereo system is NOT waterproof or water-resistant.
Water damage is not covered by the manufacturers warranty. Make sure that hands and DVDs are dry
before coming in contact with this or any electronic option.
Playing a CD
1.
Insert a disk in the disk drive as described above. The player will identify the type of disk and begin
playing it.
2.
Use either the remote control to start and stop the player and to jump to selections or use the buttons on
the faceplate.
3.
To remove the disk, press the small EJECT button beneath the disk drive slot.
Playing a DVD
1.
Raise the TV monitor as described in the following section.
2.
Turn on the TV at set the TV/VIDEO setting to VIDEO.
3.
Insert a disk in the disk drive as described above. The player will identify the type of disk and begin
playing it. Either the DVD menu will appear on the TV screen or the movie will begin playing
automatically.
4.
Use the remote control to navigate the DVD menu. To play the movie without the remote control, press
the PLAY button in the center of the row of buttons along the bottom of the faceplate.
5.
To remove the disk, press the small EJECT button beneath the disk drive slot.
Strap Removal
Manual and automatic TVs are shipped with two large plastic tie straps to prevent shipping damage. These
straps must be removed prior to operation Remove the straps using the following these steps:
1.
Remove the rear cabinet panel behind the TV monitor.
2.
Locate the two white plastic tie straps.
3.
Cut the two white plastic tie straps. USE EXTREME CAUTION not to cut any wires!
4.
Replace the cabinet panel.
The TV monitor is ready for use.
