Water Quality Maintenance
Page 56
2006 Portable Spa Owner's Manual
LTR20061000, Rev. A
Cal Inline Sanitation System Clear Water Plan
This plan and its chemical dosages are intended for
spas equipped with the optional Cal Inline Sanitation
System. The chemical references are designed for Cal
Spas chemicals only. Note: Following these
instructions is very important to ensure proper
operation of your Cal Inline Sanitation System.
Start Up -- First Day
1.
Clean surface of spa with Cal Spas “Multi-
Purpose Cleaner”.
2.
Apply a protective coat of Cal Spas “Fast Sheen”
to the acrylic surface.
3.
Fill spa to proper water level with normal tap
water (Do not use soft water)
4.
Use Bromine Test Strip and balance the spa
water:
a.
First, adjust total alkalinity (acceptable
range is 80-120ppm),
b.
Then adjust pH if necessary. (between 7.2 to 7.8)
c.
Pour in 16 oz of Cal Spas “Metal Protector” to center of spa.
d.
Sprinkle 1 oz of Cal Spas Chlorinating Granules over surface of water.
e.
Power up spa and allow it to heat to desired temperature.
Start Up--Next Day
Now that the spa has reached its normal operating temperature, it is time to add the pre-filled mineral cartridge
and bromine cartridge.
1.
Turn the power off to the spa.
2.
Take a new Cal Spas “Mineral Cartridge” and open to #6. (Hold the top of the cartridge and turn the
bottom counter clockwise)
3.
Take a new Cal Spas “Bromine Cartridge” and open to #3 (if the spa is less than 400 gallons, open to #2)
Note: These settings are start up settings only. They may need to be adjusted up or down depending on
your spa usage.
4.
Unscrew the Cal Inline Sanitation System Cap located on the top lip of the spa.
5.
Grasp the handle of the cartridge holder and turn counter-clockwise then pull up.
6.
Remove the cartridge holder and discard spent cartridges (if any)
7.
Snap the Bromine Cartridge into the bottom portion of the holder and the Mineral Cartridge into the top
portion of the holder. (make sure the cartridges go into the correct position as over-bromination will occur
if they are switched).
8.
Line up the arrow on the top of the cartridge holder with the arrow on the top of the system.
