Operating Your Spa
2006 Portable Spa Owner's Manual
Page 11
LTR20061000, Rev. A
Operating Your Spa
1500 Electronic Control Operation
Figure 4. 1500 Electronic control panel
Temperature Adjustment
Range 80°F to 104°F
The 1500 electronic control panel (Figure 4) displays the actual water temperature in Fahrenheit.
To set the water temperature:
•
Press the TEMPERATURE button. The temperature setting will flash.
•
While the display is flashing, each time you press the TEMPERATURE button the set temperature will
increase one degree.
•
Allow the display to revert back to the actual water temperature.
•
Press the TEMPERATURE button again.
•
While the display is flashing, each time you press the TEMPERATURE button the set temperature will
decrease by one degree.
Standard and Economy Modes
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When
the spa is powered up, it will automatically start in the standard heating mode. In this mode, the heating system
will automatically activate whenever the water temperature drops more than one degree below the set
temperature. In the economy-heating mode, the heating system will only activate during filtration times.
To switch from the standard heating mode to the economy-heating mode, press the “Jets/Light” button followed
by the “Temp.” then press the “Jets/Light” button. Press the same sequence to switch back to the standard
heating mode. Once in the economy-heating mode, Ec will display in the center of the control panel and flash
alternately with the water temperature.
NOTE:
There is no control panel message displayed while in the standard heating mode; only the actual water
temperature is displayed.
