Operating Your Spa
2006 Portable Spa Owner's Manual
Page 17
LTR20061000, Rev. A
6000 and 6100 Electronic Control Operation
Figure 6. 6000 and 6100 Electronic Control Panel
Initial Start up
When first powered up, it will automatically revert to Priming mode. A “Pr” on the topside display will
indicate this. Priming mode will be active for less than 5 minutes at which time the heater will be activated and
the water temperature will be maintained in Standard mode. The spa will heat to 100°F (37°C) at start up until
the set temperature is changed as described below.
Temperature Adjustment (Range 80°F to 104°F, 26°C to 40°C)
The 6000 and 6100 electronic control panels (Figure 6) display the actual water temperature in degrees
Fahrenheit. The displayed temperature will only be current after the pump has been running for at least 2
minutes.
To display the temperature that the spa is set to:
•
Press the “Temp” button. The temperature setting will flash.
•
While the display is flashing, each time you press “Temp” button, the set temperature will change up or
down one degree.
•
If the desired temperature is opposite of the direction each press of the button is making, release button,
allow display to stop flashing and then press “Temp” button to change temperature the other direction.
Standard, Economy and Sleep Heating Modes
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When
the spa is powered up, it will automatically start in standard heating mode. “St” will light briefly on the main
display. In this mode, the heating system will automatically maintain the set spa temperature. In the economy-
heating mode, the heating system will only activate during filtration times. “Ec” will display solid if
temperature is not current and will alternate with spa temperature if measured temperature is current. Economy
