Operating Your Spa
Page 12
2006 Portable Spa Owner's Manual
LTR20061000, Rev. A
Jet / Light Controls
Press the JETS button:
•
Once to activate the spa light
•
Once to activate the pump at low speed
•
Twice to activate the spa light and run the pump at high speed
•
Three times to run the pump at high speed with the spa light off
•
Four times to turn the pump off
Setting Filtration Cycles
Your spa will automatically filter itself twice a day. To set the filtration time, turn off the power to the spa at the
GFCI Breaker and turn it back on at the time of day you would like the filtration cycles to start.
Example: If you power-up your spa at 12 Noon, your filtration cycles will start at 12 noon and 12 Midnight.
The first cycle will start after the spa is powered up. The second filtration cycle will begin twelve hours later.
The filter cycle duration is preset for two hours. If spa usage is heavy, your Cal Spas™ authorized service
technician can reconfigure your system to run two five hour filter cycles.
120V/240V Conversion
The 1500 series spa is a convertible system. The conversion from 120 Volts to 240 Volts must be performed by
a licensed/bonded electrician. See 120 to 240 Volt conversion instructions, located on the inside cover of the
control box.
Note: Only spas equipped with 1.5 BHP pumps may be converted to 120 Volts. Spas with 2.0 BHP pumps or
larger can only be operated on 240 volt services.
120 Volt Heater Operation
When connected as a 120-Volt spa, the heater will only operate when the spa motor is on low speed or filtration
speed. Once the high-speed motor is engaged, the heater will automatically disengage.
Automatic Time Outs
These features will automatically turn themselves off after periods of continuous use:
•
Low-speed
pump
4
hours
•
High-speed
pump
After
30
minutes
•
Spa
light
4
hours
Diagnostic Messages
Message Meaning
OH
Overheat protection (spa is shutdown) DO NOT ENTER THE WATER! If the spa has
reached 112˚F (45˚C), remove the spa cover to cool the water. Overheating may occur if
the filter cycle is set too long. At 110˚F (43˚C), the spa should reset itself. If the high-
limit sensor detects 118˚F (48˚C) at the heater, the spa will shut down. When the heater
