2-34
Editing a Trip
While at the Trip Point screen, press the Edit
multi
-
function button. This screen allows you to
delete or move points in a trip. If you wish to delete
a waypoint, scroll to that waypoint and press Delete.
You may also change the order of the waypoints by
scrolling to a waypoint and pressing Move. Then,
turning the TUNE/SEL knob move it to the desired
location within the list. Once the waypoint is at the
desired location, press the TUNE/SEL knob or the Ok
multi
-
function button.
Plan a Route
After a destination has been entered, you must press the
Calculate multi
-
function button. The system will return
you to the map and will plan the route to your selected
destination. While the system is planning your route, the
messages “The Route is Being Calculated” and “Choose
’Stop’ to Cancel the Calculation” will appear at the
bottom of the screen.
When your route guidance has been planned, it will be
highlighted and a checkered flag will appear on the map
to show your destination. Symbols will also appear for
any waypoints that have been set. The system will
display “Route Calculation Completed” at the bottom
of the screen.
Traveling on a Planned Route
After a route has been calculated and the route
highlighted, you may hear an audio prompt to proceed
to the highlighted route. When you are ready, drive the
vehicle to the highlighted route. Once you begin driving
on the route, the system will give additional audio and
visual prompts, as you approach your next maneuver.
Each maneuver is indicated on the map with a red
maneuver pin.
Maneuver Pins
Summary of Contents for CTS 2003
Page 1: ......
