IDROSTUFE A PELLET
22
5.11 ASSEMBLING THE IDRON 16-22 AIRTIGHT / HIDROFIRE 22.8 SIDE PANELS / TESIS 16-23 AIRTIGHT
To assemble the side panels, proceed as follows:
Fig. 57 - Remove the screws
Fig. 58 - Hook the side panel
• Unscrew the screws on the cover and remove it (see
Fig. 57
).
• Hook the teeth of the side panels into their grooves (see
Fig. 58
).
Fig. 59 - Secure the front side panel
Fig. 60 - Secure the rear side panel
• Secure the side panel on the front (see
Fig. 59
).
• Secure the side panel on the back of the stove (see
Fig. 60
).
• Reposition the cover with the screws.
5.12 ELECTRIC CONNECTION
Warning: the appliance must be installed by an authorized technician!
• The electric connection occurs through a cable with plug put in an electric socket which is able to support charge and tension
specific of every model, as described in the technical datas table.
• The plug must be easily accessible when the appliance is installed.
• Please further assure you that your network is endowed with an efficient earth connection: if it does not exist or if it is not
efficient, please endow you with one in compliance with the law.
• Connect the supply cable first on the back of the stove and then at a wall electric socket.
• Do not use extension cables.
• If the feeder cable is damaged, it must be replaced by an authorized technician.
• When the stove is not going to be used for a long period of time, it advisable to remove the plug from the socket on the wall.
5.13 STOVE POWER SUPPLY
The switch on the back of the stove is used to power the system.
There is a fuse holder compartment on the back of the stove, under the power plug. Use a screwdriver to open the fuse holder
compartment cover and, if necessary, replace the fuses (3.15 A time delay).
Summary of Contents for AQUOS3 16
Page 54: ...NOTE ...
Page 55: ...NOTE ...
