11
•
TO RECALL AND START A SAVED PROGRAM:
1.
For Programs P1 through P6 (Quick Access Programs)
,
Press the
-
(P1 – P6) “Quick Access” button
corresponding to the desired program. The LED window will
show the selected Program number.
2.
For Programs P7 through P99
, (1) press the P button, (2)
then select the number of the program you wish to use by
pressing the or button until the desired program number
appears in the LED window.
3.
To start the selected program, (3) press the START / STOP
button.
•
MODIFYING THE PARAMETERS OF A SET PROGRAM:
(NOTE:
When using a program, you will be unable to modify the
cooking parameters during the cooking cycle.)
(1) Access the Program menu by pressing the P button.
(2) Use the or buttons to call to the LED display the
number of the program you wish to modify.
(3) Reconfigure the cooking parameters (Time, Temperature,
and
[
Dynamic control models only
]
Humidity if applicable) as
explained in MANUAL MODE section above (pages 7-9) .
(4) Save the program by pressing the Memory button until you hear a long beep. When the beep is
heard, the modified program is saved.
4. DOOR & FANS
•
Oven Door Safety
♦
On each Digital Convection Oven, there is a switch that stops the cook cycle when you open the door.
♦
When you open the door, the cooking cycle (in both the manual and the programmed mode) goes into
pause mode, though no cooking values are lost.
♦
When you close the door, the cooking cycle restarts from where it was interrupted.
•
Convection Fans
Every 2 minutes, the fan(s) stop and reverse direction to assure even baking.
5. CLEANING THE OVEN
•
WARNING: Before starting any maintenance or cleaning operation, it is necessary to disconnect
the electrical power supply and wait for your oven to cool down.
5.1 BEFORE USING THE OVEN FOR FIRST TIME
♦
Before plugging oven in:
Pull out & clean oven side racks and wire shelves separately (using damp cloth, hot soapy water),
then replace when done.
Clean oven cavity (using damp cloth, hot soapy water.)
♦
With the oven cavity empty, heat the oven for 30 minutes to 350°F (eliminating odors caused by
residual protective factory grease.)
♦
Never clean the oven cavity with acids, abrasives, or aggressive detergents..
5.2 GENERAL
♦
Wipe up any spills as they occur (after the oven has cooled down for 10-15 minutes.)
