10
•
TO MODIFY COOKING PARAMETERS DURING THE COOKING CYCLE
If the oven is operating in the MANUAL MODE,
it is possible to view the cooking parameters and
modify them while the oven is in its cooking cycle
.
To view the different parameters (Time, Temperature, and Humidity if applicable)
Press the STEP button until the LED corresponding to the desired STEP lights up.
Then press the SELECT button until the LED light corresponding to the desired parameter lights up.
If you select “Time”, the LED display shows the remaining time.
If you select “Temperature”, the LED display will alternate between the set temperature (steady
light) and the actual temperature (flashing light).
If you select “Humidity”, the LED display will show the percentage of humidity you originally
selected for that step.
Then use the or buttons to modify the value of your chosen parameter. The modification(s) will
take immediate effect without pressing any other buttons.
3.3
PROGRAMMED MODE
•
There is room to save up to 99 programs in your oven’s memory for “One Touch Cooking”. Each
program can have a maximum of 3 cooking steps in addition to “Preheat”.
NOTE: The 6 programs that you save by assigning to P01 – P06 will be the ones later accessed by
the
-
“Quick Access” buttons on the control panel.
(See callout #10 on page 6.).
•
TO ASSIGN AND SAVE A PROGRAM:
1.
Access the Program menu by pressing the P button, OR by
pressing a “Quick Access” button (
-
).
2.
Assign a program number between P1 and P99 as follows:
- Press any one of the
-
(P1 – P6) “Quick Access”
buttons to assign a program to one of the first 6 positions.
(We recommend saving the programs used most often in
these positions.)
- Use the or buttons to assign programs P7- P99.
3.
The program number will show in the LED display window.
4.
Set the cooking parameters (Time, Temperature, and
[
Dynamic control models only
]
Humidity if applicable.)
See MANUAL MODE section above (pages 7-9) for
how to set cooking parameters.
NOTE: If preheating is not set, the oven will propose a
temperature of 356
°
F.
5.
Save the program by pressing the Memory button until you
hear a long beep. When the beep is heard, the program is
saved.
6.
To start the program, press the START / STOP button.
7.
You may press the P button to go back into the manual
mode at any time
.
