Cadac S-Type, Installation & User Manual

Page: 18 / 74

3-2 How to use the S-Type
S-Type Revision S2005-6
61516 6HOHFWLQJ # VHQG # WR # PDWUL[ # DQG # VHWWLQJ # VLJQDO # OHYHO
By using the assignment buttons in the Sub-Group section in the respective input
module, select a Sub-Group to which the signal has been routed. On the appropriate
matrix sends section on the Group/Matrix module (8413 & 8415), enable the desired
matrix send by selecting its corresponding switch. The matrix level can then be set
using the associated matrix output level control.
To route the signal from the stereo mix bus to the matrix, select and enable the
appropriate matrix send switches on the stereo output module (8414).
Example: If you would like to send the stereo output to matrix sends 3 and 4; press
button 3 and 4 to route the left and right signal to matrix sends 3 and 4. Press SUM
L+R if you wish to route the stereo signal as a mono sum to matrix sends 3 or 4.
Note that odd numbers refer to left channels and even numbers to right channels.
616 6ROR # D # FKDQQHO #+ 'HVWUXFWLYH ,
Press Check Mute located at the top of the 8414 module, then select the appropriate
Mute button of the channel you wish to solo.
617 8VLQJ # WKH # 3)/
The S-Type has facilities for monitoring through loudspeakers or headphones, each
with its own level control for comfortable listening. Visual indication on the dual chan-
nel LED meter is also provided. The Listen facility is independent of whether the sig-
nal is in mono or stereo; it will appear in both left and right channels - either in mono
to both left and right, or in true stereo.
Unless the PFL HOLD button is selected, pressing a PFL button will cancel any pre-
viously selected PFL. Selecting the PFL HOLD function allows more than one mod-
ule PFL to be routed to the Listen bus at any one time.
61714 3)/ #0# RQH # FKDQQHO
Press the PFL button on the relevant input channel module to listen to the signal pre
fader via the listen module.
61715 3)/ #0# D # JURXS # RI # FKDQQHOV
Enable the PFL HOLD button on the 8414 module. Then press PFL on each of the
channels to be monitored.