Cadac S-Type, Installation & User Manual

Page: 15 / 74

Connections and setup 2-5
Revision S2005-6 S-Type
51618 5HSODFLQJ # D # SRZHU # VXSSO\ # XQLW
If replacing a power supply unit is required, please note the following:
■
■ ■
■
The work should only be carried out by a suitably qualified electrician.
■ ■ ■ ■
Make sure that the power supply system’s power switches are in the OFF posi-
tion and the unit is disconnected from the mains.
■
■ ■
■
Observe the correct polarity when connecting the new PSU.
■ ■ ■ ■
Note that a console must never have one voltage without the other, for example
+18V must never be fed into the console without -18V.
When switching the power supply back ON after replacement has taken place, make
sure that both LEDs on the front of the PSU-system come on. If only one LED comes
on, let go of the ON push-button immediately. Failure to do so may lead to fire hazard
and major damage to the console.
517 &RQQHFWLQJ # WKH # FRQVROH # IUDPHV
51714 )UDPH # WR # IUDPH # EXV # FDEOHV
When linking frames, plug the frame bus cable as shown in the diagram below:
Also, see Appendices .
51715 )UDPH # JURXQG # FRQQHFWLRQ
Connect the frame-to-frame grounding cable. See figure 2-6 above for the location of
the frame 0V terminals.
FIG 2-6. Audio Bus connections.
Frame 0V terminal
Frame to frame bus
connections
Frame 0V terminal