Cadac S-Type, Installation & User Manual

Page: 72 / 74

GLOSSARY-VIII
S-Type Revision S2005-6
reference ground conductor A conductor or area that provides the lowest
possible transfer impedance to the internal cir-
cuits and/or equipment, normally assumed to be
at a potential of 0V.
transfer impedance The voltage developed within a victim circuit (for
instance, a cable carrying a sensitive signal)
divided by the interference currents flowing in a
source circuit.
remote calling Function on the Osc & Comms module that
allows communication between the operator and
a remote location.
Remote MIC routing Function on the Osc & Comms module used to
route the Remote Input signal to LISTEN L and
R and the console’s TALKBACK bus.
re-route To take an existing signal route and re-direct it to
another output.
Reset Bring back to original status.
RING Part of the 0.25” TRS jack connector that carries
the out-of-phase (cold) signal.
route Signal path; direct a signal along a certain path.
Routing switches Switches used to direct the signal along a cer-
tain path.
Screen Part of a cable (also known as braid) that pro-
tects the signal conductors from electro-mag-
netic interference.
self-test After power-up of the console the CCM per-
forms a self-test during which process all of the
frames are scanned to verify the location of both
input and DC Master faders.This information is
crucial to enable correct recall of previously
saved module information for console snap-
shots for the scene recall system.
Send A potentiometer and/or switch on a module
which sends a signal onto a mixing bus.
Send Bus A set of wires accessible to all sends.
SLEEVE The part of a 0.25” TRS jack connector which is
connected to the cable screen to provide earth
connection.
SOLO See solo-in-place below.
solo-in-place Pressing the CHECK function on the Osc &
Comms module allows an operator to use input
channel MUTE buttons as a ‘solo-in-place’ for
trouble-shooting.
spur A console PSU-system in a redundant config-
uration should be connected to the same phase
and circuit
(spur).
stereo group Group module configured for stereo operation.
stereo master bus Dedicated stereo mix bus.
stereo pair Two mono input channels configured as a stereo
pair through hard-panning each channel left and
right respectively.