Cadac S-Type, Installation & User Manual

Page: 29 / 74

Stereo input module 8412 5-1
Revision S2005-6 S-Type
8 6WHUHR # LQSXW # PRGXOH #;745
The S-Type stereo input module has line level inputs for left and right channel
respectively. In addition, it features a full four-band parametric equaliser which can
be switched to pre or post the insert point. An HP-filter with a cut-off frequency of
160Hz; slope 12 dB per octave is included.
The stereo input module incorporates a fully balanced direct output with level control;
normally post fader, but may be switched to pre fader, or even post input.
The module allows routing to eight sub-groups in true stereo with optional pan con-
trol. It can also route to a dedicated stereo bus via the pan control. Additionally, it is
possible to route to eight Auxiliary busses; the first two of which are stereo on dual
concentric potentiometers - level on the upper control and pan on the lower control.
The remaining six are mono sends with level control. All eight sends can be enabled
and selected to be sourced pre or post fader on an individual basis.
Each stereo input channel can be assigned to up to eight VCA masters.
The 8412 stereo input module is equipped with a fully balanced insert send and
return - the send stays live irrespective of whether the insert button is pressed. Also,
included on the module are PFL and Mute buttons - inclusive of a destructive solo
function.
The module is fitted with a 100mm P&G fader, and located next to it, a 12-segment
meter with a range of +18dB to -36dB (meter source is pre fader). There is also a
fader-open LED, which, when extinguished, indicates that either the channel fader is
closed or muted, or an assigned VCA Master is muted or pulled down to infinity.
Following pages describes the 8412 module in detail.