Cabletron Systems SSR-ATM29-02, User Manual, Page: 60 / 386

Chapter 5: Changing System Settings
60 CoreWatch User’s Guide
6. Double-click the SNMP Trap Target object.
7. Do one of the following:
– If you are configuring a new trap target, select the Configure New Trap Target
object from the list of trap targets.
– If you are modifying an existing trap target, select it from the list that appeared
after you expanded the SNMP Trap Target object.
An SNMP Trap Target dialog box similar to the following appears:
Figure 20. SNMP Trap Target Dialog Box
8. Enter the IP address of the management station from which you want to be able to
access the traps.
Note:
The target IP address should be for a management station locally attached to
the SSR. Cold start traps might not reach their destination if the target
requires dynamic route table entries to be forwarded correctly. The system
will retry for four minutes.
9. In the Community String text box, enter the SNMP community for which you are
setting the trap target.
10. Click OK.