Cabletron Systems SmartSwitch 6E123-50, User Manual

Page: 18 / 164

Chapter 1: Introduction
1-6 2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide
1.4.4 Runtime IP Address Discovery
This feature enables the 2E42-27 to automatically accept an IP address
from a Boot Strap Protocol (BootP) server on the network into NVRAM
without requiring a user to enter an IP address through Local
Management.
When the 2E42-27 is connected to the network and powered up, Runtime
IP Address Discovery (RAD) checks the 2E42-27 for an IP address. If one
has not yet been assigned (2E42-27 IP address set to 0.0.0.0), RAD
checks to see if any of the 2E42-27 interfaces have a link. If so, RAD
sends out Reverse Address Resolution Protocol (RARP) and BootP
requests to obtain an IP address from a BootP server on the network.
The RAD requests start out at an interval of 1 second. The interval then
doubles after every transmission until an interval of 300 seconds is
reached. At this point, the interval remains at 300 seconds. The RAD
requests continue until an IP address is received from a BootP server, or
an IP address is entered using Local Management.
1.4.5 Management
Management of the 2E4X-27 is accomplished using SNMP compliant
management tools for in-band management. Out-of-band Local
Management is provided through the RJ45 COM port on the front panel
using a VT100 terminal or a VT100 terminal emulator. In-band remote
management is possible through any SNMP compliant Network
Management Software.
Local Management provides the ability to manage the 2E4X-27 and any
of the optional Fast Ethernet Interface Modules installed in ports 15 and
16 and the optional High Speed Interface Module (HSIM).
The associated High Speed Interface Module user’s guide provides
detailed information about Local Management of the HSIM.
Information about how to access and use Local Management is contained
in
Chapter 5 .