Cabletron Systems MICRO-CS, Installation Manual

Page: 31 / 93

Software Installation Procedures
Micro-CS Installation Guide 2-9
Use the slip command to modify the port parameters for the SLIP
network interface (see the slip command in Chapter 3).
Use the sequence command to list the SLIP network interface in the
load/dump interface list (see the sequence command in Chapter 3).
4. Execute the boot command (see the boot command in Chapter 3).
After successful execution of the boot command, your Micro-CS should
display the Annex prompt. If the Micro-CS was booted from the monitor
mode, the SETUP button should be depressed once to turn off the SETUP
LED.