Cabletron Systems MICRO-CS, Installation Manual

Page: 83 / 93

Micro-CS Installation Guide D-1
APPENDIX D
MICRO-CS UPGRADE INSTALLATION
D.1 GENERAL
In most cases, the Micro-CS will come factory installed and
preconfigured. However, because it is also available as an upgrade, this
section details the installation of a Micro-CS into a MicroMMAC. See the
appropriate appendices for the installation of additional memory and/or
Flash upgrades. After completing the physical installation, please return
to Chapter 2 for setup information.
D.2 LOCATING THE CONFIGURATION JUMPERS
The Micro-CS has 5 jumpers. Figure E-1 shows the locations of the
jumpers. Please note that the pins on the Micro-CS are to be read from left
to right.
Figure D-1 Jumper Locations
J25
J16
J18
J2
J10
SIMM CARDS
1 2 3 1 2 3
1
2
3