USING LANVIEW
Page 4-5
RWRP (FNB Right Wrap)
•
On - Indicates that the FNB right (trunk) connection has been
set to the wrap state by network management.
•
Off - Indicates that the FNB right (trunk) connection is in a
non-wrap state. This is the normal operating condition.
4.4
T1-SRM PORT STATUS LEDs
TST (Test)
•
On - Indicates that the T1-SRM is in test mode. This LED may
indicate internal or external loop testing. For example, the
LED lights when the service provider loops up the ETWMIM or
the ETWMIM loops back (as with power up diagnostics).
•
Off - Indicates normal operation.
LOS (Loss of Signal)
•
On - Indicates that the T1-SRM is not receiving any pulses
from the T1 circuit.
•
Off - Indicates normal operation.
YEL ALM (Yellow Alarm)
•
On - Indicates that the remote T1-SRM is in red alarm. Check
the remote T1-SRM, port cable, the Line Build Out (LBO)
setting, the Timing Mode setting, or the ESF/D4 setting.
•
Off - Indicates normal operation.
RED ALM (Red Alarm)
•
On - Indicates a service provider system failure on the
incoming line.
•
Off - Indicates normal operation.
