Model 4000C Instruction Manual
Page 18
Data Format
If the terminal was not supplied by Cablescan, the following setup data are required:
Transmission to the terminal is at 9600 Baud, with 8 data bits, 1 stop bit, no parity.
Terminal Cable
The terminal interface cable is not wired one-to-one. Data Out from the tester must be connected
to Data In on the terminal and Data In on the tester must be wired to Data Out on the terminal.
Both the Model 4000C and the Terminal have 25-pin D-type female connectors; therefore, the
interface cable has male connectors on both ends. The cable is wired as follows:
Function
Tester
25-Pin ‘D’
Terminal
25-Pin ‘D’
Data In
2
3
Data Out
3
2
Signal Ground
7
7
(Terminal Interface Cable P/N 5210789)
NOTE
Pin numbers 2 and 3 are crossed.
Pin number 7 is connected directly.
Summary of Contents for 4000C
Page 1: ...CONTINUITY TESTER MODEL 4000C Cablescan ...
Page 82: ...NOTES ...
Page 83: ...5900330 Rev C Cablescan ...
