Page 13 of 41
INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
FIT A TYPE-APPROVED (AS RE-
PORTED BEFORE) PLUG TO THE
MACHINE CABLE (THE GROUND
WIRE IS YELLOW/GREEN AND
MUST NEVER BE CONNECTED TO
ONE OF THE TWO PHASE LEADS).
MAKE SURE THAT THE ELECTRI-
CAL SYSTEM IS COMPATIBLE
WITH THE RATED POWER AB-
SORPTION SPECIFIED IN THIS
MANUAL AND APT TO ENSURE
THAT VOLTAGE DROP UNDER
FULL LOAD WILL NOT EXCEED
4% OF RATED VOLTAGE (10%
UPON START-UP).
On delivery, the machines are pre-set to operate at a
single-phase voltage of 220/240 V - 50/60 Hz.
FAILURE TO OBSERVE THE ABOVE
INSTRUCTIONS WILL IMMEDIATE-
LY INVALIDATE THE WARRANTY.
KARACTER.TLX - KARACTER.TLXFI
7108-M007-0_B
11.0 ASSEMBLY AND PREPARATION FOR
USE
After having freed the various components from the
packing check that they are complete, and that there
are no anomalies, then comply with the following in-
structions for the assembly of the components making
use of the attached series of illustrations.
11.1 Fixtures contained in the packing
The packing case contains also the fixtures box. Check
that all the parts listed are there.
KARACTER.TLX
Code
Description
N.
B1157000
Two-faced cone
1
G1000A52
Bead lifting lever
1
G1000A86
Mirror with magnetic support
1
710013421
Reverse wheels protection
1
790011620
Bead sliding foil
1
B0326001
Lever protection
1
B1205900
Rimsled, mobile insert
2
B0223000
Grease holding ring
1
203035
TE M8x20 screw
2
272172
TE M8x16 screw
4
KARACTER.TLXFI
Code
Description
N.
B1157000
Two-faced cone
1
G1000A52
Bead lifting lever
1
G1000A86
Mirror with magnetic support
1
710013421
Reverse wheels protection
1
790011620
Bead sliding foil
1
B0326001
Lever protection
1
B1205900
Rimsled, mobile insert
2
B0223000
Grease holding ring
1
203035
TE M8x20 screw
2
272172
TE M8x16 screw
4
710811600
Bracket for tank
1
201044
TE M8x45 screw
2
228011
M8 self-locking nut
2
203019
TE M6x16 screw
4
228010
M6 self-locking nut
4
