Bush Hog RTX85G, Operator'S Manual

Page: 45 / 72

OPERATION
RTXG SERIES TILLER 5/19 Operation Section 4-13
O
PE
R
AT
IO
N
© 2020 Alamo Group Inc.
Shorten the driveline profiles as follows:
• Remove the driveline from the tractor.
• Position the tiller (Lift Type - Raise and lower) to
the point with the shortest distance between
the tractor PTO shaft and implement gearbox.
Shut down the tractor and securely block the
tiller in this position.
• Pull driveline apart and reattach yoke to PTO
shaft.
• Hold driveline sections parallel to one another
and measure back 1” from yoke of each shaft
and place mark on opposite section. Cut this
length off with a saw.
• Round off all sharp edges and debur.
• Thoroughly grease then reinstall the driveline.
• Recheck for proper operation.
Engagement Check Procedure
•
With the driveline attached, position the tiller to the point where the telescoping driveline is at its maximum
extension. Completely shut down the tractor and secure in position.
• Mark the inner driveline shield 1/8” from the end of the outer shield.
• Disconnect the driveline from the tractor and separate the two driveline halves.
• Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline
profiles were engaged.
• If the engaged length is less than 6” for a non-CV driveline, the shaft is considered too short and should be
replaced with a longer shaft. Consult an authorized dealer to purchase the required driveline length.
NOTE:
When raising the tiller, at least 1” clearance must be maintained between the driveline and the tiller. If
necessary, place an upper lift stop on the 3-point hitch control lever to limit the height the tiller can be raised.
OPS-T-0015
8. PRE-OPERATION INSPECTION AND SERVICE
Before each use, a pre-operation inspection and service of the implement and tractor must be performed.
This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped
and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection
reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing
parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time
and repair cost can be avoided.
OPS-U-0029
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, or Drivelines could turn without warning and cause immediate
entanglement, injury or death.
(S3PT-11)