![background image](http://html1.mh-extra.com/html/bush-hog/rtx85g/rtx85g_operators-manual_2834873037.webp)
OPERATION
RTXG SERIES TILLER 5/19
Operation Section 4-5
O
PE
R
AT
IO
N
© 2020 Alamo Group Inc.
3. TRACTOR REQUIREMENTS
The tractor used to operate the implement must have the power capacity to lift, pull, and operate the Power
Take Off (PTO) at the implement’s rated speed while traveling at a ground speed between 2 and 5 MPH.
Operating the implement with a tractor that does not meet the following requirements may cause tractor or
implement damage and be a potential danger to the operator and passersby. Operating the implement with a
tractor that does not have adequate power may damage the tractors engine. Exceeding the required
horsepower may cause damage to the implement by over powering the unit in heavy tilling conditions.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower:
RTX85G..................................50 - 120 HP
RTX92G..................................50 - 120 HP
•
Hitch- Lifting Capacity
RTX85G..................................1100 Lbs.
RTX92G..................................1150 Lbs.
3-Point Hitch ...........................RTX85G - Cat. 1 & Cat. 1 QH - Cat. 2 & Cat.2 QH
3-Point Hitch ...........................RTX92G - Cat. 1 & Cat. 1 QH - Cat. 2 & Cat.2 QH
•
Front End Weight .......................................... As needed to maintain 20% weight on front axle
•
Power Take Off.............................................. 540 RPM 6-spline, 1-3/8” diameter output shaft
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer.
OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or even
death could result from falling off the tractor, particularly during a turnover when
the operator could be pinned under the ROPS.
(SG-7)
Summary of Contents for RTX85G
