32
Operating guidelines
Volume
Speech
Rington
The volume level for the voice feedback and the selected ring tone can
be set in an additional sub menu.
Available as voice commands are
„LOUDER“
,
„LESS“
,
„MAXIMUM“
,
„MINIMUM“
and
„ACCEPT“
.
For some radios it may cause problems if the HFCK starts with voice
response immediately after the mute signal. Some radios need some
time for a corresponding activation and reaction to the mute signal.
This will be indicated to you through the fact that you don’t hear the
signal tone at the start of the voice control. To avoid this effect, you can
enter a maximum delay of up to three seconds in the
„MUTE DELAY“
menu item. It is only after this time has elapsed that the HFCK begins
with the voice feedback.
Certain mobile telephones offer the possibility of being able to install
and operate a navigation solution. On many mobile phones, the sug-
gested directions are only transferred via the
Bluetooth
A2DP profile. If
you have not connected a suitable cable to the LINE-OUT output of the
HFCK and to the radio however, you are not able to hear these instruc-
tions.
With the
External Audio
menu item, it is possible to place these in-
structions on the PHONE-OUT output of the HFCK. This means that the
direction instructions are read out in monotone and the radio is also
muted. The HFCK takes priority with its functions, however, which me-
ans that if the voice control is active or in the event of an incoming call,
any direction instructions that are being issued at that time will be
muted.
Please note:
If the function is activated it is not possible to listen to
X
music via A2DP via the LINE-OUT output.
Mute delay
External audio on
