CCD
Operator's manual
Page 20 /35
Detailed Instructions
Control unit and mechanics
Power supply
The machine power supply has a wide range AC input. You can run it on any common single
phase mains supply. If the power cord supplied with the machine is not suitable for your country,
please replace it. In this case it is urgently required that you ensure correct grounding to PE.
Attention!
You must disconnect the machine from the main supply and wait until DC voltages are
low prior to opening the control unit or to pulling cards off from it. We deny any liability if alterations
to any mechanical, electric or electronic components of the machine are made. Prior to any manip-
ulation to the control unit, check that the machine has been disconnected from the main supply.
Control unit
MTC, ATC: There is a stand-alone control unit with 3 cable connections to the mechanics unit.
There are one cable with 25 pin Sub-D connectors and two cables with 15 pole Sub-D connectors.
The connections are unique and cannot be interchanged.
CCD/2: The control unit is located underneath the mechanics unit, but the power supply comes as
a stand-alone box and connects to the machine back by one cable.
Pic. 1: ATC Controller
Pic. 2: CCD/2 Power supply till
2013
From 2013 industrial power supply
Pic. 3: CCD/2 control unit (back view)
4: CCD/2 control unit (front view)
