CCD
Operator's manual
Page 23 /35
Spindle accessories
A drill pressure foot and a depth limiter are supplied in the box with the spindle, as well as some
cleaning tools for the spindle chuck.
Drill pressure foot
The drill pressure foot serves to push the board down before the drill bit hits it. This is particular
useful if the board is not flat and plain or if you drill more than one board at once (you can drill
stacks of 3 boards of 1.6 mm). Also this pressure foot serves as a protection so that you cannot
touch the rotating tool. It is fixed to the spindle shaft by the screw with the black knob.
ATC: The drill pressure foot can stay on the spindle shaft during automatic tool change. It is
though necessary that the slot in the foot faces towards the tool holders, in a position as shown in
picture 10.
MTC: The pressure foot must be removed for tool change. After each tool change the drill pres-
sure foot must be put back in place for safety reasons.
Depth limiter
During milling/routing, the depth limiter (DL) achieves a regulation of the Z axis work level in order
to compensate for uneven board surfaces. The device is designed to work with tools that we sup-
ply, especially those of the G30 and G60 type. Note: The DL is not compatible with the cooling
Abb. 9: Drill pressure foot .
12: Depth limiter ...
11 .... mounted to spindle
10 ..... mounted to spindle
