CCD
Operator's manual
Page 14 /35
Close the machine configuration and go to
the tab
Manual Operation
.
Check the function of the axis by clicking on
the arrow buttons. When you first click on
one arrow, the machine will perform a refer-
ence drive. Make sure that the control di-
odes light up when reaching the 0-position.
You can also check the function of spindle
as well as camera, dispenser or laser, if
there.
ATC:
Check the function of the tool
changer. Go to tab
General
and click
on
Open
to load the project file
ccd_PCB_-14tools. (XL-Version: -25
Tools). This project file is located after
a
normal
installation
at
C:\Users\Public\Documents\ccdpro-
jects\pcb.
Go to tab
Run CNC
and click on
the triangle
START
. The next
dialogue asks you to place the
tool to the corresponding tool
slots. Make sure that the tools
have a length of 38 mm and the
distance between the top of the
ring to the tool tip is 21 mm. Fur-
thermore, a test tool must be in
the spindle and the tool slot 0
must be empty. Check the cor-
rect fitting of the tools in the
slots. Since there are tolerances
in the ring diameters, it can be
necessary to adjust the slots.
You can easily widen them with
a screwdriver and tighten them
by pressing from outside against
the lamellae.
Press
OK
. The machine now
moves to the tool sensor, checks the test tool and places it in slot number 0. Then the spindle moves
back to the sensor to check whether the tool was correctly dropped. After that it continues to slot
number 1 to load the first tool. The length of tool 1 is checked at the sensor, the spindle starts and a
positioning and drilling movement is performed. After that the machine checks if the tool is not
broken and sets the tool again in slot 1. This cycle is repeated until all 14 (XL 25 ) tools are checked.
Please be prepared to either press the
ESCAPE
key ( = emergency stop ) on your keyboard or click
on the red
X
in the top left in the RoutePro3000 window to directly stop the machine in case the tools
were not picked properly or a collision is about to happen. This may happen in case of a transport