CCD
Operator's manual
Page 16 /35
….... and click Start. The machine will perform a reference
run. Make sure that all 3 end switch diodes light up. With an
ATC machine the software will ask for test tool in the spindle
and whether the tools are correctly positioned in the ATC bar.
Again take care that slot 0 is free!
With a manual machine, you are asked to insert the current
tool into the spindle.
After clicking
OK
, the drilling begins. This is fully automatic with an ATC. For manual machines,
the first tool is processed, then the machine moves up into the Z limit switch and you will be
prompted to insert the next tool.
When the drill layer is
finished change to the
routing layer
With click on
Start
the machine again makes a reference
run and the processing is carried out in the same manner as
with drilling.
If you do not use a depth limiter and a discoupled spindle,
but get the milling height from the software, you can com-
pensate tolerances in backing board and PCB by clicking
PgUp
and
PgDn
. After the next vector the machine will con-
tinue routing with the changed height.
The change you made is displayed on the upper right (c
ur-
rent tool values
) at
depth.
