Bullhorn SDT16 Family, Installation And Configuration Manual, Page: 45 / 110

SDT16 Family Installation and Configuration Guide
Chapter 2. Installation 35
Figure 2-6. External Antenna
b.
Attach the antenna surge protector according to the Antenna Surge Protector Quick Install
Guide included with the antenna surge protector kit.
c.
From the bottom of the bracket, insert the brass mount (included with the antenna
cable) in the mounting hole on the bracket.
d.
From the top of the bracket, place the antenna on the brass mount and then twist the
antenna clockwise to tighten.
e.
Apply silicon adhesive around the base of the antenna to help secure it during high
wind or other extreme weather conditions.
f.
If a factory-installed antenna cable is connected in the antenna port on the modem
(satellite transceiver) located inside the enclosure, disconnect the cable from the
antenna port and secure it to the inside of the enclosure using a tie wrap and adhesive
tie wrap holder. For location of the antenna port, refer to the appropriate figure in
Bullhorn System Overview on page 2.
g.
Using the antenna cable on the external cable, route the antenna cable through the
water-tight fitting on the bottom of the enclosure and then connect it in the
Antenna
Port
on the modem.
h.
Continue with step
5.
on page 39.
4.
If you are working with a unit that uses the SkyWave-Inmarsat satellite network for
communications (the STD16-SAT), install the satellite terminal using the instructions in
step
a
or step
b
.
Complete step
a
to install the satellite terminal in a non-hazardous location:
a.
Assemble the satellite terminal, mounting bracket, and u-bolt in the following manner:
(1)
Remove four (4) screws labeled
A
and
B
or
C
and
D
(Figure 2-7).
Surge Protector