Bullhorn SDT16 Family, Installation And Configuration Manual, Page: 46 / 110

SDT16 Family Installation and Configuration Guide
36 Chapter 2. Installation
Figure 2-7. Removing the Satellite Terminal Screws (Non-Hazardous)
(2)
Install the satellite terminal on the mounting bracket (Figure 2-8) using four #6 x
5/8 Plastite screws provided in the installation kit.
Figure 2-8. Mounting Bracket and Satellite Terminal (Non-Hazardous)
(3)
Plug the mating connector on the interface cable in the connector on the bottom
of the satellite terminal. Apply non-conductive silicon grease on the mating
connector and then wrap with waterproof sealing tape.
(4)
Create a strain relief for the interface cable using a tie wrap and one of the
mounting holes on the mounting bracket as shown in the next figure.
(5)
Fasten the u-bolt and mounting bracket to the satellite terminal mounting bracket
using two
¼
–20 nuts and split washers (Figure 2-9). Tighten hardware using an
adjustable wrench.
(6)
Continue with step
c.
on page 38.
Satellite Terminal
Mounting Bracket
Interface Cable
#6 x 5/8 Plastite Screw
(4 Places)