Bullhorn SDT16 Family, Installation And Configuration Manual, Page: 48 / 110

SDT16 Family Installation and Configuration Guide
38 Chapter 2. Installation
Figure 2-10. Satellite Terminal Assembly (Hazardous)
(3)
Route the mating connector on the interface cable through the adapter base and
gasket.
(4)
Plug the mating connector on the interface cable in the connector on the bottom
of the satellite terminal. Apply non-conductive silicon grease on the mating
connector and then wrap with waterproof sealing tape.
(5)
Install the adapter base on the satellite terminal using four (4) threaded studs,
washers and nuts.
(6)
Fasten the u-bolt and mounting bracket to the satellite terminal mounting bracket
using two
¼
–20 nuts and split washers as shown in the previous figure. Tighten
hardware using an adjustable wrench.
(7)
Install the adapter base on the satellite terminal mounting bracket by routing the
interface cable through the mounting hole on the bracket and then using the lock
nut to secure the terminal. When you finish, continue with the next step to install
the satellite terminal assembly.
c.
Install the satellite terminal assembly on the mounting surface using the u-bolt (Figure
2-11). The satellite terminal must face in the direction of the Inmarsat satellite that is
located southeast of the United States.
Satellite Terminal
Gasket
Adapter Base
(1 ¼ inch PVC Male Threaded Conduit Adapter)
Satellite Terminal Mounting Bracket
Interface Cable
U bolt and
Mounting Bracket
Lock Nut
Washer and Nut
(4 Places)
¼ 20 Nut and
Split Washer
(2 Places)
Create strain relief for terminal
interface cable using tie wrap
and available mounting hole.
Threaded Stud
(4 Places)