6
4.
Attach leg glides (inside tool box) to legs. Set near maximum extension.
5.
Remove the shipping tabs, keep the screws and
place one of the washers under
each 6mm x 16 socket head screw
6.
Have all of the 6mm leg mounting screws barely started with one washer on each. If
there is no washer, the screws will bottom out and not secure the leg.
7.
Attach the legs with 4 6mm socket screws and washers
each, using a 5mm Allen wrench with an extension
.
A 5mm Allen bit is included in the tool box.
Two people are required.
Stand the base unit on the end of the drain pan and have
one person support it in that position while the other
attaches the legs.
DO NOT APPLY PRESSURE TO THE
LEAD SCREW, LEAD SCREW SUPPORTS or LEAD
SCREW GUARDS!
8. Level the machine
by placing your most accurate level
on the X1 bearing rail (the aluminum extrusion deep
end of the pan). Adjust the leg glides for an exact left to
right level. Repeat on the X2 bearing rail extrusion. Note that common levels are
not sensitive enough. When leveling is as close as you can get it, adjust the leg
glides on the left end so that both x1 and x2 lead screws touch their stops
simultaneously.
9.
Run the x axis to about 6” from the right side stops before installing the x axis motors
by turning both lead screw knobs located on the left end.